Upgrading the Headlight Bulb on a Suzuki VX800 Motorbike

I’ve obtained a Suzuki VX800 motorbike, and like many older single headlight bikes, the sunshine output on each dipped or foremost beam is poor. The low output limits seen distance at night time, and so limits pace, and likewise signifies that the blinding impact of oncoming automobiles is extra pronounced.

I selected an Osram Evening Breaker +90% bulb with a H4 becoming appropriate for the bike. These bulbs declare to offer 90% extra gentle output, however nonetheless match into the usual becoming, and draw the traditional 60/55 watts. Which means they’re a direct alternative to the present normal headlight bulb. I did contemplate upgrading to a Xenon HID headlight, however a correct improve equipment prices significantly extra, and requires including a ballast unit and modifying the bulb wiring.

Becoming the brand new Osram Evening Breaker Headlight Bulb

The method for changing the bulb is strictly the identical as for many single lamp ‘bare’ bikes. This is a fast abstract:

  • First job was making an attempt to get into the Osram Evening Breaker packaging! Take away all of the paper cowl, press on the highest of the case to unclip it, after which slowly work the entrance half and again half aside. They’re held collectively by tabs on the prime and backside, and take somewhat power to get aside.
  • Unscrew the headlight unit retaining screws – on this bike, they’re on the edges of the headlight unit. The screws can corrode, during which case apply some penetrating oil and await 10 minutes to stop you rounding the heads off. Take care to not alter the smaller screw on the entrance. That is used to regulate the angle of the beam to stop dazzling oncoming site visitors. As soon as unscrewed, the headlight unit will pull ahead out of the rear cowl men gifts B07X9PVKM2.
  • Disconnect the facility cables to the headlight bulb, and the parking gentle bulb. As soon as that is accomplished, you possibly can take away the rubber waterproofing cowl, and unscrew the retaining ring by turning anticlockwise by a small quantity.
  • Now take away the present bulb and change with the Osram Evening Breaker +90%. Take care to not contact any a part of the glass along with your fingers, as filth or oil could cause the bulb to overheat and probably shatter. The H4 bulb will solely go in a method spherical to make sure the dipped and foremost beam works appropriately.

Leave a Reply

Your email address will not be published. Required fields are marked *